The Naulong Water Resources Development Project (WRDP) is located at Latitude 28.44 N and Longitude 67.34 E in district of Jall Magsi, Baluchistan, Pakistan. Seismic hazard assessment (SHA) is prepared for calculating design and drawing design response spectrums at the coordinates of dam body with using active faults nearby project site, occurred earthquakes and local site conditions. The dam is located at the boundary of two major tectonic plates. This boundary, located west of the intersection of the Eurasian and Indian plates, has created the Kirthar Fold and Thrust Belt. The Kirthar Fault and Thrust Belt is one of the well-defined unequivocally active faults not only in Pakistan but also in World. The block where the dam is located is the hanging wall block of The Kirthar Fault and Thrust Belt. The hanging wall lies above the fault plane and moves relative to the footwall. In reverse and thrust faults formed by compression, the hanging wall is pushed up over the footwall, commonly at convergent boundaries like the Eurasian-Indian plate boundary. Obtaining Vs30 value is the first step for soil site conditions in updated revision of seismic hazard assessment. It is determined by the results from the studies of "Multi - Channel Analysis of Surface Waves (MASW), at site. With MASW studies, S-wave velocity measurements were applied to a depth of 50 m, also foreseeing stripping excavation. The average of S wave velocities from the bottom of the stripping excavation to a depth of 30 meters will represent the value Vs30. Vs30, the time-averaged shear wave velocity (Vs) to a depth of 30 meters. This value also gives an idea that the rocks are quite weak and easy to excavate and stiffness of local site conditions. This value is an important indication because the behavior of earthquake waves is related to Vs30 values based on design procedures. As a result of MASW studies, 600 m/s (rock site) and 400 m/s (soil site) are measured for deterministic seismic hazard analysis (DSHA) and probabilistic seismic hazard analysis (PSHA). This level is symbolized “C”, “C” and “B” site class according to Building Code of Pakistan - 2021, ASCE 7 - 16 and Eurocode 8, respectively. For the SHA, first of all, a circle with a radius of 200 km is drawn with the dam at the centre. The relationship of the faults within the circle with the project site is observed. From the year 1960 through 2025, a total of 2363 earthquake records are obtained greater than magnitude 4.00 or equal from seventeen different catalogues. Duplicated seismic events are removed from obtained all earthquakes according to reliability ranking resulting in 926 seismic events. Foreshocks and aftershocks are removed according to Gardner and Knopoff (1974) procedure. Moreover, completeness magnitude (Mc=4.0) is determined and data (403 records are left) is ready for the analysis. Finally, recurrence parameters are calculated with Weichert (1980) method. Open Quake (version 3.16.2) and EZ - FRISK (version 8.06) is run with using “Abrahamson et al. (2014)”, “Boore et al. (2014)”, “Campbell & Bozorgnia (2014)” and “Chiou & Youngs (2014)” ground motion prediction equations (GMPEs) for suggested researchers by International Commission on Large Dams (Bulletin 148, 2016). The final results for PSHA are given as the geometric mean of the Open Quake (Version 3.16.2) and EZ-FRSIK (Version 8.06) outputs.