The wastewater from paper recycling industry can be serious threat to the environment owing to the presence of organic and particulate pollutants, reflected in elevated chemical oxygen demand (COD), total suspended solids (TSS) and turbidity. If inadequately treated, the wastewater can cause significant environmental impacts and loss of reusable fibers. In this study, a combined coagulation/flocculation-dissolved air flotation (DAF) process was investigated to improve mill-water treatment performance with a particular focus on fiber recovery and reuse. An optimized concentration of coagulation/flocculation was developed through jar tests using polyaluminium chloride (PAC) as coagulant and polyacrylamide (PAM) as flocculant. The optimized PAC-PAM conditions achieved 84% turbidity removal, 81% TSS removal and 80% COD removal, with the treated water pH adjusted to 7.8. These conditions were then applied to a pilotscale DAF unit. Under DAF operation, removals increased to 88% for turbidity, 84% for TSS and 88% for COD, while approximately 84% of the suspended solids were recovered as a concentrated, fiber-rich sludge. A paper sheet was produced from this treated sludge showed about 50% higher strength compared with paper made from raw sludge, confirming the good papermaking quality of the recovered fibers. Overall, the findings demonstrate that coupling coagulation-flocculation with DAF can significantly enhance mill-water treatment and enable high-quality fiber recovery, supporting more sustainable and resource-efficient paperrecycling operations