No Detail Found!

Evaluation of physiochemical properties and microstructure of cement paste blended with saponified cooking oil and cetrimonium chloride

Author(s)
Abdel Fattah A. Qaraman Inorganic and Analytical Chemistry, Israa University,Gaza, Palestine,
Abstract
Sustainable development relies on recycling environmental resources, which includes the recycling of liquid and solid wastes by using them as obtained or after treatment. One such environmentally burdensome material is the used cooking oil, which this study examines after its treatment through saponification and blending with CTAC as a cationic surfactant. The study evaluated five cement paste mixes with different concentrations, ranging from 0% to 5% of saponified cooking oil (SCO). The results pointed out that SCO enhanced the workability and air content (0-30%) but therefore reduced density (2.0-1.39 g/cm³), thermal conductivity (0.72-0.25 W/m•K), and compressive strength (72.7-32.22 N/mm²) as a result of increasing porosity. On the other hand, water absorption decreased by 69% at 1%. SCO outperforms traditional foam cement due to SCO's hydrophobicity. Microstructural analysis (SEM) shows a homogeneous distribution of air voids in the cement paste matrix (~63.1 µm). The cement pastes with SCO dosages (1-5%) were blended with 1% cetrimonium chloride cationic surfactant (CTAC). The results show an increase in the air content (up to 49.5%) and therefore a reduction in density down to 1.010 g/cm³, thermal conductivity (0.20 W/m•K), and compressive strength (15.4 N/mm²) as a result of increasing porosity. On the other hand, water absorption increased about eight times compared to the reference sample at (5% SCO + 1% CTAC) due to high porosity. In conclusion, the utilization of SCO admixture resulted in a significant alteration in the performance of cement pastes. The addition of SCO has a positive effect on cement paste's permeability-related properties by reducing the water absorption into the hardened cement pastes, improving thermal insulation, and making them especially suitable for lightweight construction materials where moisture control is critical. Still, their mechanical characteristics are slightly decreased but within acceptable limits in these cases. These findings highlight the unique behavior of saponified cooking sunflower oil used in cement matrices. When 1% CTAC is blended into the SCO cement mix, the thermal insulation is improved due to the increase in the air content, but this addition reversely affects both compressive strength and water absorption, and remains in the acceptable range for a nonconstructive building material.
Publication Details
Page(s) 1215-1224
DOI DOI not available
Published Journal: ARPN Journal of Engineering and Applied Sciences, Volume: 20, Issue: 15, Year: 2025

Request the full text from PASTIC

Keywords
microstructure, surface-active agents, physiochemical properties, sustainable construction materials, cetrimonium chloride (CTAC), compressive strength, pore structure, saponified cooking oil, green additives, cement paste
References
Abbas M.,Abdelzaher M.,Awad A.,ResearchGate Abbas M.,Abdelzaher M.,Awad A. .2024 .Production and characterization of sustainable geopolymers from industrial wastes. Materials, 14(9) : 1234.
ResearchGate Abdelzaher M. .2023 .Utilization of ceramic waste in geopolymer production: A sustainable approach. Journal of Cleaner Production, 312 : .
Construction Building,Materials Building . .. , 250 : 118850.
Abdelzaher M.,Awad A. .2022 .Influence of high alkynes on ultra-fine ceramic waste in geopolymer composites. Journal of Building Engineering, 45 : 103456.
ResearchGate Alnuaimi A. S.,Al-Jabri K. S.,Al-Saidy A. H. .2020 .. , : .
. .Characteristics, strength development, and microstructure of hardened cement paste containing oil-contaminated sand. Construction and Building Materials, 238 : 117704.
.2019 .. , 117704 : .
. .. , : .
. .Standard test method for compressive strength of hydraulic cement hardened cement paste s (using 2-in. , : .
.2008 .Standard test method for density (unit weight), yield, and air content (gravimetric) of concrete (ASTM C138/C138M-. , : .
ASTM .2019 .Standard test method for steady-state heat flux measurements and thermal transmission properties by means of the guardedhot-plate apparatus (ASTM C177-. , : .
ASTM .2021 .Standard test method for density, absorption, and voids in hardened concrete (ASTM C642-. , : .
Adeyemi AWogbemi O.,Ogunbode A.,E. A. .2019 .. , : .
Baghban M. H. ,Ghafoori N.,Ramezanianpour A. A. . .. , 10(3) : 45-52.
. .Effect of oil contamination on the properties of concrete. Journal of Materials in Civil Engineering, 24(9) : 1123-1130.
Standards Institution British .2016 .Methods of testing cement - Determination of setting times and soundness. BSI Standards Publications., : .
Buczek B. .2014 .Influence of oil-contaminated sand on the strength of cement mortar. Construction and Building Materials, 65 : 123-130.
Cechova M. .2009 .Properties of cement mortars with oilcontaminated aggregates. Cement Wapno Beton, 14(2) : 67-73.
Li Chen D.,Wang Y.,X. Y. .2024 .Microstructural analysis of geopolymer pastes incorporating oilcontaminated sand. Construction and Building Materials., : .
Camões Eires R.,Jalali A.,S. A. .2017 .Enhancing the water resistance of earthen buildings with quicklime and oil. Journal of Cleaner Production, 142 : 3281-3292.
Tan C. H.,Lee K. T. .2022 .Recent advances in the conversion of waste cooking oil into value-added products: A review. Fuel, 307 : 121782.
Liu Han Y.,Zhang X.,Y. X. .2014 .Effect of oil contamination on the mechanical properties of concrete.. , : .
. .. Journal of Materials in Civil Engineering, 26(5) : 987-994.
Sandbakk Justnes H.,S. Justnes H. .2008 .Concrete with reduced cracking. In Proceedings of Nordic Concrete Research, 37 : 184-185.
Roy Karmakar S.,Ghosh S.,P. S. .2017 .Utilization of oilcontaminated sand in cement mortar: A sustainable approach. Journal of Cleaner Production, 142 : 1234-1240.
Dupont Libessart L.,Martin F.,J. F. .2023 .Incorporation of oil-contaminated sand in concrete: Environmental and mechanical considerations. Resources, Conservation and Recycling, 180 : 106123.
Chen Liu Y.,Zhao X.,L. X. .2018 .Physical and mechanical properties of cement mortar containing fine sand contaminated with light crude oil. Construction and Building Materials, 160 : 123-130.
Chen X.,Zhao L. .2020 .Influence of oil contamination on the durability of cement-based materials. , : .
. .. Journal of Materials Research and Technology, 9(4) : 7890-7898.
Maotsela T.,Mofokeng T.,Dhlamini M. .2019 .Effect of oil-contaminated sand on the compressive strength of concrete. Journal of Building Engineering, 25 : 100813.
Slížková Nunes C.,Z. Nunes C. .2014 .Hydrophobic lime-based mortars with linseed oil: Characterization and durability assessment. Cement and Concrete Research, 64 : 50-58.
0

Citations

0

Downloads

21

Views