No Detail Found!

Effect of blade layering on vertical axis wind turbine performance under low wind speed conditions

Author(s)
M. F. Basar Faculty of Electrical Technology and Engineering,Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, Durian Tunggal, Melaka,Malaysia
N. I. B. M. Farriz Faculty of Electrical Technology and Engineering,Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, Durian Tunggal, Melaka,Malaysia
A. M. Norazizi Faculty of Electrical Technology and Engineering,Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, Durian Tunggal, Melaka,Malaysia
I. A. Zulkarnain Faculty of Electrical Technology and Engineering,Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, Durian Tunggal, Melaka,Malaysia
Ngatono Department of Computer Systems, Faculty of Information Technology,Universitas Serang Raya, Banten,Indonesia
K. Sopian Department of Mechanical Engineering,Universiti Teknologi Petronas, Seri Iskandar, Perak Darul Ridzuan,Malaysia
Abstract
This study investigates how blade layering influences the performance of a proposed Savonius Vertical Axis Wind Turbine (SVAWT) tailored for low wind speed conditions. The proposed SVAWT is simple to construct using basic, locally available materials such as polyvinyl chloride pipes for blades and a recycled fan rotor as the generator. Experimental tests were conducted using single-layer and double-layer blade configurations, with blade diameters of 0.05 m (2”), 0.10 m (4”), and 0.15 m (6”). Both configurations used six arm blades per layer. Key performance metrics, including electrical power output and efficiency, were measured at wind speeds ranging from 4.8 m/s to 5.3 m/s. Results show that the double-layer configurations significantly improved energy capture and power output. The best performance was achieved with the 0.15 m (6”) six-blade double-layer setup, producing 7.3 W of electrical power and an efficiency of 10.3%. The experimental findings demonstrate that the proposed SVAWT generates higher power and efficiency as wind speed increases. Additionally, increasing the blade diameter and adopting a double-layer configuration further enhances the turbine's ability to harness wind energy. Overall, the results highlight that blade layering is a crucial design factor for improving the efficiency and effectiveness of small-scale wind turbines in low wind speed areas.
Publication Details
Page(s) 651-655
DOI DOI not available
Published Journal: ARPN Journal of Engineering and Applied Sciences, Volume: 20, Issue: 13, Year: 2025

Request the full text from PASTIC

Keywords
energy efficiency, low wind speed, vertical axis wind turbine, Savonius wind turbine, blade layering
References
Khan F. H.,Pal T.,Kundu B.,Roy R.,Resources Renewable,IEMRE Renewable .2021 .5 February 2021 Institute of Electrical and Electronics Engineers Inc. , : .
Kocak E.,Alnour M. .2022 .Energy Rand D expenditure, bioethanol consumption, and greenhouse gas emissions in the United States: Non-linear analysis and political implications. Journal of Cleaner Production, 374 : 133887.
Basar M. F.,Rais N. A. M,Azhan A. R.,Mustafa W. A.,Sopian K.,Wong K. V. .2022 .Optimization of Reaction Type Water Turbine in Very Low Head Water Resources for Pico Hydro. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 90(1) : 2339-39.
Zainuddin H.,Khamis A.,Yahaya M. S.,Basar M. F. M.,Lazi J. M.,and Ibrahim Z. J. M. .2009 .December. Investigation on the performance of a pico-hydro generation system using consuming water distributed to houses. the 1st International Conference on the Developments in Renewable Energy Technology (ICDRET), : 1-4.
Negemiya A. A. .2023 .Fabrication of a Combined Savonius-Darrieus Wind Turbine. International Journal for Research in Applied Science and Engineering Technology, 11(5) : 536-540.
Aras M. S. M.,Ali F. A.,Azis F. A.,Hamid S. M. S. S. A.,Basa M. F. H. M. .2011 .September. Performance evaluation and comparison of two algorithms for the Fuzzy Logic rice cooking system (MATLAB Fuzzy Logic Toolbox and FuzzyTECH). In, : 400-405.
Harun M. H.,Aras M. S. M.,Basar M. F. M.,Abdullah S. S.,Annuar K. A. M. .2015 .Synchronization of the compass module with the pressure and temperature sensor system for an autonomous underwater vehicle (AUV). Journal Teknologi (Sciences & Engineering), 74(9) : .
Basar M. F.,Sapiee R.,Rahman S.,Borhan Z.,Sopian S.,K. S. .2014 .Cost analysis of pico hydro turbine for power production. AENSI Advances in Environmental Biology, 8(14) : 147-151.
Abdallah S.,Eisa S.,Hoying M. .2023 .Novel Augmented-Blades Savonius Wind Turbine with Preliminary Experimental Validation. 19 April, : 6-9.
Mohd Aras M. S. ,Abdullah S. S.,Othman S. Y.,Mohd Zambri M. K S. Y.,Kamarudin M. N. .2016 .Fuzzy logic controller for depth control of underwater remotely operated vehicle. Journal of Theoretical and Applied Information Technology, 91(2) : 275-288.
Halim M. F. M. ,Yaakub M. F.,Harun M. H.,Annuar K. M.,Omar M. N. .2019 .An analysis of energy saving through delamping method. International Journal of Electrical and Computer Engineering (IJECE), 9(3) : pp1569-1575.
Yaakub M. F.,Basar M. F.,Yahaya M. S.,Mohd Noh F. H M. S.,Kamarudin H. Z. .2017 .A micro-power generation from a rain shower utilizing a PZT and PVDT piezoelectric transducer. ARPN Journal of Engineering and Applied Sciences, 12(22) : 6285-6290.
Rathod U. H.,Kulkarni V. .2023 .Development of a Novel Drag-Based Vertical-Axis Wind Rotor Inspired by the Orange Sea-Pen. In: Sustainable Energy Generation and Storage, : 1-12.
Zhang L.,Qu J. .2021 .Study on Aerodynamic Performance of a Combined Vertical Axis Wind Turbine Based on Blade Element Momentum Theorem. Journal of Renewable and Sustainable Energy, 13(3) : .
Basar M. F.,Norazizi A. M.,Mustaffa I.,Colin C. T.,Mirin S. N. S.,Jano Z. S. N. S. .2021 .Investigation on the Performance of a Portable Power Generation System with a Low-Cost Vertical Axis Wind Turbine. , 11(6) : 7809-7813.
Chong M. Y.,Rahman A. A.,Aziz N. A.,Khamis A.,Basar M. F. M. .2010 .Performance comparison of bidirectional converter designs for renewable power generation. International Power Engineering and Optimization Conference (PEOCO), : 101-106.
Patel U. K.,Alom N. .2024 .Aerodynamic Analysis of a 2-Stage Elliptical-Bladed Savonius Wind Rotor: Numerical Simulation and Experimental Validation. International Journal of Green Energy, 21(1) : 102-115.
Rais N. A. M.,Basar M. F. .2021 .Pico-Hydro Generation System: Empirical Investigation on a Novel Z-Blade Low-Head Low-Flow Water Turbine. International Journal of Renewable Energy Research (IJRER), 11387(1) : 108-113.
Al-Gburi K. A. H .2022 .A Comparative Study Review: The Performance of Savonius-Type Rotors. Materials Today: Proceedings. 57, : 343-349.
Coelho P. .2023 .The Betz Corresponding Thermodynamic Engineering. , 47(2) : 491-496.
Kong Johan Kong N.,Abu Bakar R.,Adnin Hamidi M. Bakar R. .2020 .The Analysis of Wind Blade on the Performance of Vertical Axis Wind Turbine. IOP Conference Series: Materials Science and Engineering, : .
Damanik N.,Purba S.,Calle M. A. R. S.,Kurniawan M. A. .2021 .An 18 Slot, 8-Pole Permanent Magnet Synchronous Generator for Small-Scale Wind Turbine Energy Conversion: Design, Fabrication, and Experiments. , 1150(1) : 012022.
Salem H.,Mohammedredha A.,Alawadhi A. .2023 .High Power Output Augmented Vertical Axis Wind Turbine. Fluids, 8(2) : .
Didane D. H.,Ab Wahab A.,Shamsudin S. S.,Rosly N. .2016 .Wind as a sustainable alternative energy source in Malaysia: a review. ARPN Journal of Engineering and Applied Sciences, 11(10) : 6442-6449.
Rami S.,Rzouq S. .2024 .Exploring airborne wind energy: A comparative study and the potential for implementation in Jordan. ARPN Journal of Engineering and Applied Sciences, : 975-991.
0

Citations

0

Downloads

19

Views