This study aimed to analyze heavy metals and microbiological quality of ground water (GW) and surface water samples (SW) in Khyber Pakhtunkhwa, Pakistan. Different parameters including color, turbidity, electrical conductivity (EC), pH, salinity, biological oxygen demand (BOD), heavy metal ions detection, total dissolved solids (TDS) and detection of coliforms were analyzed. The obtained results were matched with World Health Organization (WHO) prescribed standards. The pH values were from 7.92 to 8.61 and 7.98 to 9.60 in GW and SW respectively. The value of TDS in GW and SW ranged from 354 to 576 ppm and 118.9 to 671.1 ppm respectively. BOD of GW was 0.10 to 0.70 ppm and in SW from 72.9 to 126.07 ppm. The Copper (Cu) concentration in GW and SW was varied from 0.0091 to 0.1066 mg/L and 0.0046 to 0.0080 mg/L, respectively. The Iron (Fe) range was -0.1673 to 0.3848 mg/L in GW, while in SW it was 0.1419 to 0.2712 mg/L. The Zinc (Zn) value ranged from 0.1177 to 0.1860 mg/L and 0.0987 to 0.1224 mg/L in GW and SW respectively. Manganese (Mn) in GW and SW ranged from 0.0551 to 0.1546 mg/L and -0.1278 to -0.1426 mg/L, respectively. MPN value was from 12 to 1600 MPN/100ml. All parameters of GW fell within the WHO desirable limits except GW2, whose pH deviated from the WHO permissible limit. While the SW was not within WHO recommended values. After practicing suitable disinfection procedures, surface water can be used for agriculture and household activities.