No Detail Found!

Soil moisture sensing and signal evaluation for planters.

Author(s)
Muhammad Shafi Sabir Farm Machinery & Power Department, University of Agriculture, Faisalabad, Pakistan
Muhammad Iqbal Farm Machinery & Power Department, University of Agriculture, Faisalabad, Pakistan
Muhammad Younis Farm Machinery & Power Department, University of Agriculture, Faisalabad, Pakistan
Gerald C. Zoerb Agricultural Engineering Department, College of Engineering, University of Saskatchewan, Saskatoon, Canada
Abstract
This paper describes the capabilities and limitations of soil moisture-electrical resistance relationship as a means of providing a usable signal for controlling seeding depth. Disk, J shape and knife electrodes were employed in both configurations as two and four-electrode probes. An a.c. regulated current of 1000 Hz was passed between the electrodes and the resulting potential drop was rectified and then displayed on a strip chart recorder. The voltage change with a change in moisture content was found quite substantial. The typical voltages measured across the two electrode knife probe were 13.4 and 0.60 volts for approximately 4 and 18 percent soil moisture content for sandy loam soil. The response time of this sensor to a step change in the moisture content was about 75 milliseconds.
Publication Details
Page(s) 1-9
DOI DOI not available
Published Journal: Journal of Engineering and Applied Sciences, Volume: 10, Issue: 1--2, Year: 1991

Request the full text from PASTIC

0

Citations

0

Downloads

32

Views