No Detail Found!

Effect of exposure methods and concentrations on infectivity of Beauveria bassiana in Atteva sciodoxa Meyrick (lepidoptera: Yponomeutidae).

Author(s)
Ghulam Ali Bajwa Pakistan Forest Institute, Peshawar, Pakistan
Faizah Abood Faculty of Forestry, University of Putra Malaysia, 43400 UPM Serdang, Malaysia
Yusof Bin Ibrahim Faculty of Technical and Vocational Education, Sultan Idris Education University, Perak, Malaysia
Abstract
Effect of exposure methods and concentrations on infectivity of Beauveria bassiana were assessed in Atteva sciodoxa infesting a medicinal plant, Eurycoma longifolia. The conidial suspension was used in three exposure methods including inoculation of: both, larvae and leaves, only larvae and only leaves. Five concentrations: 5×106, 1×107, 5×107, 1×108 conidia mLG1 and a control were applied in a two-factor factorial design. The results indicated highly significant effect of exposure methods on infectivity. Pooled larval infectivity across the inoculating concentrations was ranged between 38.1±3.21% and 94.6±2.40% in three exposure methods. An infectivity of 54.1±1.74% was occurred due to secondary acquisition of conidia from spray residues on the foliage. A hundred percent infectivity was caused by concentration of 5x107 conidia mLG1 when either both larvae and leaves or only larvae were inoculated. The difference in infectivity varied significantly among exposure methods at lower concentrations compared to the higher concentrations. The median effective time was found dependent on exposure method and inoculum concentration. An inoculum of 1×108 conidia mLG1 gave 50% larval infectivity in about three days when both larvae and leaves were inoculated. Based on these findings, it is concluded that infectivity can be enhanced through secondary acquisition from foliage by infecting larvae escaped during direct exposure or by overcoming physical defence mechanism of the larvae adopted momentarily in response to spray stimulus.
Publication Details
Page(s) 249-254
DOI DOI not available
Published Journal: Science, Technology and Development, Volume: 34, Issue: 4, Year: 2015

Request the full text from PASTIC

0

Citations

0

Downloads

87

Views