At present, elastomeric latexes, which mainly consist of hydrocarbon substances, are being increasingly used in civil engineering applications as modifiers, especially for the purpose of improving performance of hydraulic cement concrete. However, unlike most cement concrete modifiers, where the normal production process is barely unchanged, inclusion of elastomers into cement concrete, requires additional techniques to the conventional production process. This paper reports experimental findings regarding extra production techniques for optimum performance in latex-modified concrete. To identify and categorize the most effective approach, a series of normal and latex-modified concretes were designed and produced based on conventional as well as modified production processes. In the process, the roles of mixing procedure, workability, setting time, water/cement ratio, latex dosage and curing regime were studied. Homogeneity in latex-cement blends was monitored through endothermic activities of differential scanning calorimetry. In addition, superiority among specimens was assessed through compressive strength. Results show that performance of latex-modified concrete depends largely on the techniques involved in the mixing procedure, water/cement ratio, latex content and curing regime. Thus, unless normal practices involved in the production of conventional concrete are appropriately adjusted, the optimum performance of elastomeric concrete may never be achieved.