No Detail Found!

Effects of solar collecting area and water flow rate on the performance of a sand bed solar collector.

Author(s)
Abdul Latif Maganhar Department of Mechanical Engineering, Quaid-e-Awam University of Engineering, Sciences & Technology, Nawabshah, Pakistan
Abdul Hameed Memon Department of Mechanical Engineering, Quaid-e-Awam University of Engineering, Sciences & Technology, Nawabshah, Pakistan
Muhammad Ibrahim Panhwar Department of Mechanical Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
Abstract
The often discussed renewable sources of energy have been of great interest to energy researchers and planners for quite some time. The primary source of renewing all sources of energy is the sun. There have been two main problems not yet fully resolved. One is the large scale production of energy and other is the cost factor. In the present study, the cost factor is under consideration. In this regard a non-conventional solar collector using indigenous material (pit sand) as solar absorber is designed and manufactured. This paper presents the results of an investigation of the effect of solar collecting area and water flow rate on the performance of a pit sand bed solar collector especially in terms of rise in water temperature. Three pit sand solar collectors of area lm2 each were connected in series to enhance the collecting area and the system was tested for different flow rates. Experimental results proved that there was increase in water temperature with increase in solar collecting area and decrease in water temperature with increase in flow rate.
Publication Details
Page(s) 369-376
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 24, Issue: 4, Year: 2005

Request the full text from PASTIC

0

Citations

0

Downloads

40

Views