Chemical, mechanical and thermal properties of Phenolic based prepregs with addition of different ratios of fillers (Graphite powder, Alumina and Silicon Oxide) have been studied. Surface treatment of silica and carbon tape have also been studied both by physical and chemical methods. Studies regarding effect of resin concentration, filler concentration, soaking time and semi-curing temperature was carried out for the development and manufacturing of carbon-Phenolic and silica-Phenolic Prepreg Material Control Microscopy was used for the determination of uniform soaking and loading of Phenolic resin on reinforcement. The thermal properties of carbon and silica reinforced Phenolic insulators were determined by thermogravimeteric (TGA) and differential scanning calorimetric (DSC) analysis. Mechanical properties (Breaking strength, Tensile strength and % elongation) of silica Phenolic and carbon Phenolic reinforced composites were also measured and correlated to the stabilization of processing parameters. Finally the filler parameters for the development of phenolic-based prepregs were optimized.