Magic-T is a four-port passive microwave device that can be viewed as a combination of H-type and E-type waveguide T-junctions. It is mostly used as a mixer in radar receivers and as a building block of monopulse comparator in tracking radars. An ideal Magic-T is required to provide high isolation between the two output arms. Practical Magic-T, however, significantly deviates from these ideal parameters. This is mostly because of manufacturing imperfections and impedance mismatch. This paper discusses the design, manufacturing and testing of a Ku-band Magic-T hybrid junction. Impedance matching is carried out by using an iris-reactive post combination. Computer simulations were performed to calculate and optimize various design parameters. Finally, prototype manufacturing was carried out using two different machining facilities. These prototypes were tested on S-parameter Vector Network Analyzer. Comparison of practical measurements with the simulation results is presented. Also, variations in measured results due to machining imperfections are analyzed.