No Detail Found!

Error model development and simulation of fault detection and isolation of redundant inertial measurement unit.

Author(s)
Asif Iqbal National Engineering and Scientific Commission (NESCOM), Islamabad, Pakistan
Perveen Akhter National Engineering and Scientific Commission (NESCOM), Islamabad, Pakistan
Ali Bin Shahid Masood-Ur-Rehman National Engineering and Scientific Commission (NESCOM), Islamabad, Pakistan
Abstract
This paper presents error model development and sensors configuration of a Redundant Inertial Measurement Unit (RIMU) required for expensive mission programs. The redundancy is achieved in rate channels by incorporating three dynamically tuned gyros (DTGs) while acceleration information is obtained by using three flexure quartz accelerometers. To accomplish the redundancy the gyros are mounted in a skewed-sensor configuration so that their sensitive axes are at some angle to RIMU sensitive axes. A complicated error compensation model is needed to be developed due to redundancy. The error model of this new configuration has been discussed and a method of failure Detection and Isolation (FDI) for the system is introduced. The Simulation of this process is performed which showed a reliable and fail-safe operation of the system.
Publication Details
Page(s) 159-167
DOI DOI not available
Published Journal: Proc 3rd Int Bhurban Conf Appl Sci Technol, Volume: 0, Issue: 0, Year: 2003

Request the full text from PASTIC

0

Citations

0

Downloads

54

Views