Traditionally in Pakistan the well screen materials used for strainer type tube wells in the deep alluvial aquifers of the Indus Plain have been mild steel wrapped with coir in the private sector, and fiberglass in the public sector. This tradition of public sector use of fiberglass has been reviewed in the light of reduced cost differentials between stainless steel and fiberglass well screens, and the relative performances of the two materials in the tube wells of Khairpur SCRAP-I project. Here, it was found that the performance was similar, with stainless steel well screens producing slightly lower energy losses, but unable to provide superior long-term performance. These factors, together with recent cost rate, have been combined in to an economic comparison of the relative costs of the two well screen materials. From the field data it is observed that the minimum length of fiberglass screen required for maintaining an entrance velocity below 0.1 feet per second is 80 feet. This paper aims the economical standardization of tube well screening material, depending upon cost benefit ratio, which may be used by both public as well as private.