Abnormal pressures zones are the major problem in the drilling and exploration of oil and gas. Due to these abnormal pressure zones, several drilling challenges are faced, and overhead cost may result. This study is focused on the identification of these abnormal pressured zones using high resolution geophysical logs drilled through the reservoir formations of Chanda Oilfield, Kohat basin, Pakistan. Petrophysical analysis is carried out to identify clean and shaly zones. The well-known Eaton empirical method is used for calculation of overburden, pore pressure and fracture gradient. Based on the results, three overpressure zones are identified i.e. Patala Formation (Chanda-1), Chichali Formation (Chanda-1, -2 and Chanda Deep-1) and the contact of Mianwali and Chiddru formations (in Chanda Deep-1). Estimated outputs were calibrated and validated with the available direct downhole measurements (formation pressure measurements, LOT/FIT). Shear failure gradient was calculated using Mohr-Coulomb rock failure criterion to understand the wellbore stability issues in the studied field. Largely, the pore pressure in the reservoir formations is hydrostatic in nature, except the lower Cretaceous to upper Jurassic shales, which were found to be associated with mild overpressure regimes. The finding of this study will be used to reduce the non-productive time during drilling and exploration that prevent the hazardous activities associated with oil and gas exploration and drilling i.e., blow out and lost circulation and designing the casing point according to formation conditions. Furthermore, this study marks the normal and abnormal pressures zones in the selected wells of the Kohat basin and the results will help the oil and gas industry in safe and economical drilling