The Indian model of the biogas digester has been introduced in the country during the last three decades, whereas the Chinese dome-type design could not be introduced due to the skills required for construction of this digester. The other problem associated with Chinese dome-type digester is that large quantities of solid waste are needed to fill the digester. The Chinese dome-type digester constructed on experimental basis could not perform satisfactorily. The Indian Model, although popular in the country, is not environment friendly and is of high cost, both fit terms of capital investment and O&M. It creates quite dirty environment around the digester due to the free movement of slurry. It also creates problems of mosquitoes, as the environment is conducive for their breeding. Taking into consideration, these limitations, design of polyethylene capsule-type digester (with black carbon and UV stabilizers) was developed, using water tanks normally constructed for domestic water storage by the local plastic companies. Modification was made in the PE water tank and one of the local companies collaborated to manufacture the capsule-type digester. Solid waste is introduced from the top, whereas the slurry can be disposed from the bottom through a controlled valve. Thus input of solid waste and slurry-disposal is now within the choice of the owner. The slurry can be disposed into a tank, where it can be composted to reduce the pH, before its use for agriculture. The PE capsule-type black-color digester is also attractive for increasing the temperature of the digester due to black body absorption. The production of gas during summer season might take a few days, whereas additional greenhouse effect during winter can raise the temperature by 10 oC. Hence, this digester is more suitable for cooler regions where the Indian model is not successful. The design is modular in nature; therefore linking additional modules in series can increase the capacity of biogas production. The other prevailing problem with the commonly used biogas digester is that the gas pressure is low. In the PE Capsule-type digester, gas is stored in the used rubber tubes, where putting load on the tubes can easily increase the gas pressure. Thus pressure of the gas can be maintained very effectively. Adding inoculums of the methogenic bacteria can increase the production of the gas. Lime has to be added to increase the pH, because methogenic bacteria are effective in neutral to alkaline environment, instead of the acidic environment, which is commonly experienced after adding solid waste into the digester. Temperature is another important parameter for enhancing productivity of biogas. The system is cost-effective, as the total cost is around Rs. 10,000 for a unit producing gas to light a single burner for 40-100 hours. The technology transfer will be easy, as the private plastic companies can market such systems more effectively than the public sector. Four modules of this system more can be installed with the cost of one Indian-type model.