No Detail Found!

Soil plugging of open-ended steel piles during impact driving

Author(s)
Jamila El Brahmi Civil, Hydraulic and Environmental Engineering Laboratory (LINCHE), Mohammadia School of Engineers (EMI), Mohammed V University in Rabat (UM5),RABAT,Morocco
Othmane Hniad Civil, Hydraulic and Environmental Engineering Laboratory (LINCHE), Mohammadia School of Engineers (EMI), Mohammed V University in Rabat (UM5),RABAT,Morocco
Imane Elkasimi Civil, Hydraulic and Environmental Engineering Laboratory (LINCHE), Mohammadia School of Engineers (EMI), Mohammed V University in Rabat (UM5),RABAT,Morocco
Yousra Marghoub Civil, Hydraulic and Environmental Engineering Laboratory (LINCHE), Mohammadia School of Engineers (EMI), Mohammed V University in Rabat (UM5),RABAT,Morocco
Abstract
During the driving process of an open-ended steel pile, soil is allowed to enter the pile's core until partial or complete plugging occurs. Once this phenomenon is activated, soil resistance to driving (SRD) increases, which can prevent further soil introduction inside the pile, and in turn halt installation works under similar conditions. In this paper, we demonstrate the relationship between the plugging phenomenon, pile geometry, and driving acceleration by comparing literature with some conducted experiments (Paikowsky, 1990; Magroun, 2012), which show that the risk of plugging decreases mainly with an increase in both pile diameter and driving acceleration. A verification study of plugging occurrence in terms of depth is conducted on an open-ended driven pile at a Moroccan port terminal crossing predominantly sandy layers before anchoring in a lower marl layer. The pile's bearing capacity is evaluated in both plugged and unplugged cases using the SRD method following the processes of Toolan and Fox (1977) and Alm and Hamre (2001), and based on cone penetration test (CPT) results. The pile is thus found unlikely to plug during driving. As a general rule, we found that the plugging phenomenon must be controlled to avoid any interruption in the pile driving process.
Publication Details
Page(s) 2296-2303
DOI DOI not available
Published Journal: ARPN Journal of Engineering and Applied Sciences, Volume: 18, Issue: 20, Year: 2023

Request the full text from PASTIC

Keywords
bearing capacity, open-ended pile, pile driving, CPT, plugging, soil resistance to driving SRD
References
Randolph M.,Gourvenec S. .2011 .. , : .
Turton .1982 .Evaluating drivability for hard clay, very dense sand, and rock. In: Offshore Technology Conference. One Petro., : .
Smith E. A. L. .1960 .Pile Driving Analysis by the Wave Equation. Journal of the Soil Mechanics and Foundations Division, ASCE, 86 : 35-64.
Toolan F. E. D. A.,Fox D. A. .1977 .Geotechnical Planning of Piled Foundations or Offshore Platforms. In: Proceedings of the Institution of Civil Engineers 62.2, : .
0

Citations

0

Downloads

33

Views