No Detail Found!

Synthesis and characterization of photoanode by immobilisation of pyridyl complexes on ITO for photo-conversion system

Author(s)
Anis Kharul Nada Mohd Yusuf Department of Chemistry, Faculty of Science and Mathematics, Universiti Pendidikan Sultan Idris, 35900 Tanjong Malim, Perak, Malaysia.
Suzaliza Mustafar Department of Chemistry, Faculty of Science and Mathematics, Universiti Pendidikan Sultan Idris, 35900 Tanjong Malim, Perak, Malaysia.
Ma. Leah Borines Department of Chemistry, University of Connecticut, 55 North Eagleville Road, Unit 3060, Storrs, Connecticut, U.S.A.
Etty Nurlia Kusumawati Chemistry Course, Faculty of Science and Engineering, Iwate University, 4-3-5, Morioka, Iwate 020-8551, Japan.
Yusnita Juahir Department of Chemistry, Faculty of Science and Mathematics, Universiti Pendidikan Sultan Idris, 35900 Tanjong Malim, Perak, Malaysia.
Noorshida Mohd Ali Department of Chemistry, Faculty of Science and Mathematics, Universiti Pendidikan Sultan Idris, 35900 Tanjong Malim, Perak, Malaysia.
Norhayati Hashim Department of Chemistry, Faculty of Science and Mathematics, Universiti Pendidikan Sultan Idris, 35900 Tanjong Malim, Perak, Malaysia.
Abstract
Increasing developments on the application of copper complexes as dyes are due to their dual function in dye-sensitized solar cells (DSSCs) as redox mediators and dye sensitizers. The economical (abundance, low cost) and environmentally friendly properties of copper motivate researchers on the use of copper complexes for replacement of ruthenium-based dyes in solar cells. A novel [Cu(I)(2,9-dmp)(phen-dione)]PF6 (A2) bearing polypyridyl ligands, 1,10- phenanthroline-5,6-dione (phen-dione), 2,9-dimethyl-1,10-phenanthroline (dmp) was prepared by metal complexation reaction. The photofunctionality of A2 as a promising photosensitizer in DSSCs was studied. Interestingly, A2 exhibited two absorption peaks, one is detected in the ultraviolet region due to ?-?* transition and the other is a metal-to-ligand charge transfer (MLCT) band at 405nm in the visible region. A2 was compared to the same complex with Cu(II) ion as the metal centre which only absorbed light in the ultraviolet region thereby implying limited use of Cu(II) complex in its light harvesting application. The photofunctionality of A2 was studied by employing it as an active material for photoelectric conversion by engaging it with ITO to create a photoanode. Upon light irradiation, an anodic current was observed. In conclusion, introduction of Cu(I), instead of Cu(II), in polypridyls ligands resulted in successful enhancement of photophysical properties of A2, making the photoanode of A2 suitable for light harvesting applications.
Publication Details
Page(s) 86-93
Published Journal: Pakistan Journal of Analytical & Environmental Chemistry, Volume: 24, Issue: 1, Year: 2023

Request the full text from PASTIC

Keywords
Photoanode, Photocurrent, Solar cells, Coordination chemistry
0

Citations

0

Downloads

55

Views