No Detail Found!

Flexural strength of modified and unmodified acrylic denture base material after different processing techniques

Author(s)
Aisha Kiran Baqai Medical University, Karachi, Pakistan
Faiza Amin Dow University of Health Sciences,Karachi, Pakistan
Syed Junaid Mahmood PCSIR, Labs Complex, Karachi-Pakistan
Arif Ali Dow University of Health Sciences,Karachi, Pakistan
Abstract
Background: Conventional heat cure polymerized acrylic resin(unmodified) is most acceptable denture base material in dentistry since decades. It has been modified with reinforcement of fillers and different processing techniques were introduced to enhance its mechanical and physical properties. The objective of this research is to determine and compare the effect of different processing techniques on flexural strength of modified and unmodified denture base acrylic resin. Air circulating oven is introduced for the first time in this study and its efficacy is also compared with other conventional processing techniques. Methods: In this study total number of 114 rectangular specimens were fabricated by conventional heat cured acrylic (Stellon QC 20, Dentsply) for Group A (n=57), and rubber reinforced acrylic resin (High impact, Meadway) for Group B (n=57). Three equipment including water bath, dry oven and air circulating oven were utilized for processing specimens individually. Each sub-group of processing techniques (n=19) were tested for flexural strength through a three-point bending test by a universal testing machine. The statistical analysis initiated with descriptive analysis followed by independent t test for mean comparison of flexural strength of all three processing techniques among both testing group. One-way ANOVA and 2-way ANOVA followed by Scheffe post hoc test were also applied. p-value of 0.05 or less was considered as significant. Results: Statically significant p-value <0.001 was found in response of flexural strength in all processing techniques (water bath, dry oven, air circulating oven) of both testing groups. Water bath processing demonstrated highest flexural strength values in both denture base material used in this study. The unit used for flexural strength was MPa. Conclusion: This study manifested highest flexural strength in conventional and rubber reinforced heat cure samples when processed through water bath. Air circulating oven also presented acceptable flexural strength in conventional heat cure acrylic resin specimens when compared with other techniques.
Publication Details
Page(s) 672-677
DOI DOI not available
Published Journal: Journal of Ayub Medical College, Volume: 32, Issue: S1, Year: 2020

Request the full text from PASTIC

Keywords
Water bath, Rubber reinforced acrylic resin, Conventional heat cured acrylic resin, Dry oven, Air circulating oven, Processing technique
0

Citations

0

Downloads

39

Views