No Detail Found!

Mechanical behavior of composite and FGM transmission-back hub automotive drive shaft using finite element method

Author(s)
Saeed Asiri Mechanical Engineering Department, Engineering College King Abdulaziz University. P.O. Box-80204 Jeddah 21589, Saudi Arabia.
Abstract
Recently, to improve vehicle energy conservation, composite materials are used but, these materials may be replaced one day with functionally graded materials (FGMs). FGM is also a composite of two components, characterized by a compositional gradient from one component to the other. This study modeled total deformation and natural frequency, under the subjected load of a car hollow drive shaft using steel, four layers' composite, and FGM drive shaft. The analysis is carried out using ANSYS and results were compared. The deformation values are shown in the results. It concludes that FGM material is comparatively better than the other two. It is noticed that; fiber angle orientation of the composite drive shaft has a great influence on both deformation and first frequency also, offers lower deformation than steel while FGM offers lower deformation than steel and composite. Also, in buckling and harmonic analysis, FGM material deformation is minimum.
Publication Details
Page(s) 207-213
DOI DOI not available
Published Journal: Science International, Volume: 33, Issue: 3, Year: 2021

Request the full text from PASTIC

Keywords
steel, Driveshaft, FGM, Finite element., Composite material
0

Citations

0

Downloads

84

Views