Gasification is a process in which fuel is converted into syngas which can be used as an alternative for natural gas. The main objective is to convert the plastic waste into syngas through a gasifier. Plastic waste is nondegradable waste that leads to accumulation in the earth and causes an environmental burden. The main purpose was to work on the fabrication of a gasifier that can be utilized for the conversion of plastic waste into energy which can be used for many purposes. The temperature required for this process is 700 C-1000C. Plastic was shredded through a shredder was done which exhibits the characteristics of feeding material. The sample analysis in analytical balance device, electric oven, muffle furnace, fixed bed gasifier, gas chromatography. In this study, three types of different plastic waste samples taken, and each sample took two samples and the equal total weight of sample on 750g and 900g, on different temperatures. The samples run in a gasifier through different scenarios. Scenario two is producing good quality syngas 431g to 465g average according to rising in temperature 300C. The efficiency of scenario two is 52.14% which should be more to make it environmentally sustainable. The composition of gas which had produced has 4.9-6.1% CO, 8-10.4% H2, 22-23% CO2, 1.1-1.6% CH4 and 57-63% other gases were present such as nitrogen, NOx, Sox and water vapors.