Design of an energy efficient air curtain in particularly vertical refrigerated display cabinet has become a new challenge. The classical air curtain in a closed circuit is a longitudinal jet of cold air blown through a nozzle and sucked back by a longitudinal recovery arrangement. For a better understanding of the dynamics of air curtains, complex and case specific geometries for a fully stocked refrigerated display cabinet can be reasonably simplified to that of a plane air wall jet. A jet is said to be a wall jet, if it is blown near a wall, Wall jet has immense applications in refrigerated display cabinets, Jet cutting, cooling through impingement, heat insulation, inlet devices in ventilation, separation control in airfoils and film cooling of turbine, heating, ventilation and airconditioning and various industrial applications. This study aims to develop an experimental prototype to study the interaction between plane air jet confining cavity and a transverse cross-flow. To validate the proper working of the experimentally developed prototype (especially energy efficient air curtain), in the first step an academic configuration was studied which is plane air wall jet, where analytical solutions and experimental measures are available. In the prototype as well as for the numerical investigation, the plane air wall jet was investigated by using two different nozzles of 4cm and 2cm widths respectively through whom air is blown by the blower at 5m/s from top to bottom on a rectangular two dimensional domain of 0.4x0.5 m2' The obtained experimental measurements, using Laser Doppler Velocitymetry (LDV), are compared to numerical results obtained by the commercial CFD code Fluent using different turbulent models and correlations proposed in the literature for the mean velocity profiles, maximum velocity decay, flow entrainment, friction coefficient and turbulence properties.