No Detail Found!

Failure analysis of a high pressure butt-weld flange.

Author(s)
F. Ahmed Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
F. Hasan Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
L. Ali Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
Abstract
This paper constitutes the failure analysis of a 24-inch diameter ‘Flange’ that had been welded to a high-pressure gas transmission pipeline. The flange had ruptured catastrophically during the hydrostatic test that was conducted to testify the integrity of the flange as well as that of the weld joint. The rupture had occurred along the weld through the heat-affected-zone (HAZ) on the flange side. The flange, which was a steel forging (of Class 600 as per ANSI Standards) made from ~0.25 % carbon steel, was expected to exhibit good weld ability. However, the metallographic examination revealed that the steel had a coarse grain-size and an in-homogenous microstructure wherein pearlite-rich regions, ~2-3 mm across in size, were sporadically distributed in the microstructure. The coarse grain-size coupled with the presence of pearlite-rich patches in the microstructure had locally reduced the weld ability of the steel, i.e., increased its tendency towards HAZ cracking during welding.
Publication Details
Page(s) 26-32
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 3, Issue: , Year: 2008

Request the full text from PASTIC

0

Citations

0

Downloads

38

Views