No Detail Found!

Slippage of steel in high and normal strength concrete.

Author(s)
K. Ahmed Civil Engineering Department, University of Engineering & Technology, Lahore, Pakistan
Z. A. Siddiqi Civil Engineering Department, University of Engineering & Technology, Lahore, Pakistan
M. Yousaf Civil Engineering Department, University of Engineering & Technology, Lahore, Pakistan
Abstract
Composite action of any reinforced concrete member is only possible if sufficient bond strength exists between steel reinforcing bars and concrete, which can adequately transfer shear stress between them. Bond strength is a function of compressive strength of concrete and hence high strength concrete has higher bond strength. Therefore required development length can be reduced. In order to investigate the effect of development length on bond stress and slip relationships, experimental investigation was carried out. In this experimentation 24 pull-out samples of high strength concrete and normal strength concrete were casted and tested. The results of this investigation revealed that by increasing the development length from 5db to 10db bond strength increases for both high and normal strength concrete. However incase of normal strength concrete increase in bond strength is more compared to that in high strength concrete. The increase in bond strength is observed even at 10db development length but the extent is less for 19 mm than 16 mm bars. This is in agreement with the earlier findings of Chen et al and Harajli et al. However incase of HSC the total slippage at 10 db is 50% greater than at 5db. This may be due to the fact that more no of concrete keys participate in resisting the slippage.
Publication Details
Page(s) 31-39
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 1, Issue: , Year: 2007

Request the full text from PASTIC

0

Citations

0

Downloads

37

Views