No Detail Found!

Silica-fume made concrete in tension.

Author(s)
Aneel Kumar Department of Civil Engineering, Mehran University of Engineering & Technology, Jamhsoro, Pakistan
Ghous Bux Khaskheli Department of Civil Engineering, Mehran University of Engineering & Technology, Jamhsoro, Pakistan
Abdul Latif Sanjarani Department of Civil Engineering, Mehran University of Engineering & Technology, Jamhsoro, Pakistan
Abstract
Silica fume is used as a cement replacement material in concrete. Sufficient work is carried out to observe the effects of silica fume on compressive strength of concrete. However, the effect of SF (Silica Fume) on tensile strength of concrete is not well reported. This study is thus aimed to determine the effect of silica fume on tensile strength of concrete. In total 72 cylinders were manufactured with 1:2:4 (Binder: FA: CA) ratio. Three different classes of concrete were used. In Class-1, only the cement was used as the binding agent, in class-II, 7.5% of silica fume+92.5% of cement was used as the binding agent and in the Class III, 8.5% of silica fume +91.5% of cement was used as the binding agent. These three concrete classes are called as 0% SF, 7.5% SF and 8.5% SF respectively. Results show that better early tensile strength can be obtained by using 8.5% SF concrete at lower w/b ratios, but for higher w/b ratios, the 7.5 SF concrete can give better early tensile strength. The better 28th day tensile strength can be obtained by using 7.5% SF concrete while the use of 8.5% SF concrete can give lower 28th day tensile strength.
Publication Details
Page(s) 507-514
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 29, Issue: 3, Year: 2010

Request the full text from PASTIC

0

Citations

0

Downloads

25

Views