No Detail Found!

Controller Design for the Rotational Dynamics of a Quadcopter.

Author(s)
Rabia Rashdi Department of Mechatronics Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Zeeshan Ali Department of Industrial Engineering & Management, Dawood University of Engineering & Technology, Karachi, Pakistan
Javed Rahman Larik Department of Mechanical Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Liaquat Ali Jamro Academics & Training, Sindh Technical Education and Vocational Training Authority, Tano Jam, Pakistan
UROOJ BAIG Department of Mechatronics Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
Researchers have shown their interests in establishing miniature flying robots to be utilized for, both, commercial and research applications. This is due to that fact that there appears to be a huge advancement in miniature actuators and sensors which depend on the MEMS (Micro Electro-Mechanical Systems) NEMS (Nano-Electro Mechanical Systems). This research underlines a detailed mathematical model and controller design for a quadcopter. The nonlinear dynamic model of the quadcopter is derived from the Newton-Euler method and Euler Lagrange method. The motion of a quadcopter can be classified into two subsystems: a rotational subsystem (attitude and heading) and translational subsystem (altitude and x and y motion). The rotational system is fully actuated whereas translational subsystem is under actuated. However, a quadcopter is 6 DOF (Degrees of Freedom) under actuated system. The controller design of a quadcopter is difficult due to its complex and highly nonlinear mathematical model where the state variables are strongly coupled and contain under actuated property. Nonlinear controller such as SMC (Sliding Mode Controller) is used to control altitude, yaw, pitch, and roll angles.Simulation results show that the robustness of the SMC design gives a better way to design a controller with autonomous stability flight with good tracking performance and improved accuracy without any chattering effect. The system states are following the desired trajectory as expected.
Publication Details
Page(s) 269-274
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 38, Issue: 2, Year: 2019

Request the full text from PASTIC

References
Santos, 2010., 141 -146
Li, 2011.Analysis  and  PID  Control for  a  Quadrotor”, 573 -578
Salih ,  A.L.,H.A.F. ,  and  Gaeid,K.,Information,Security, 2015.Controller  Design  for  a  UAV Quadrotor”, 4 2249 -555
Peddle ,   I.K., 2008.Control  of  a  Ducted  Fan (SLADe)”, 16 1770 -1775
Herrera ,  M.,  Chamorro,  W.,  Gómez,  A.P.,Camacho , O., 2015.Control: An Approach  to  Control  a Quadrotor”, 314 -319
Nabil,Ph, 2007.Modeling  and  Control  of  a Quadrotor  Using  Linear, -
Koshkouei , A.J.,  Burnham,  K.J.,  and  Zinober,  A.S.I.,July, 2005.,IEE Proceedings  of  Control  Theory  &  Applications 4 392 -396
Wang,Zhao, 2016., 498 -503
Doukhi ,  O.,  Fayjie,  A.R., 2017.Design  for  Quad-Rotor  Stabilization  in Presence  of  Parameter  Variations”, 1 -10
Bouabdallah, S., “Design and Control of Quadrotors with Application to Autonomous Flying”, Ph.D. Thesis, Ecole Polytechnique Feìdeìrale de Lausanne, 2007
0

Citations

0

Downloads

41

Views