No Detail Found!

Study of Erosion Corrosion Behaviour of Magnesium and its Alloys.

Author(s)
S Jayabharathy Department of Mechanical Engineering, Sri Manakula Vinayagar Engineering College, Puducherry,
P Mathiazhagan Department of Mechanical Engineering, Pondicherry Engineering College, Puducherry, India
Abstract
Erosion Corrosion is the degradation of material by means of combined effect of mechanical flow and chemical reactions with the surrounding environment. Light weighting of automobiles has been a critical issue in the transportation industries. Magnesium alloy seems to be the best promising next generation's material and as a substitute to aluminium alloy and steel that are being used in automotive, aerospace industries. In this study ,Magnesium,AZ31 and AZ91 were used to investigate the erosion corrosion rate and corrosion rate in 3.5% wt NaCl .The experiments involved the measurement of weight loss .Experimental setup was used to carry out the erosion corrosion test. Immersion test was conducted to determine the corrosion rate. Results include erosion corrosion analysis, comparative analysis of erosion corrosion and corrosion rate. Further SEM analysis was done to study the microstructure behaviour of the samples. It was found that the corrosion rate increases as time of exposure increases. It was also inferred that the erosion corrosion rate is higher than corrosion rate due to moving fluid under the same environmental condition.
Publication Details
Page(s) 71-74
DOI DOI not available
Published Journal: Pakistan Journal of Biotechnology, Volume: 15, Issue: S2, Year: 2018

Request the full text from PASTIC

References
Altun H . and S.,Sen, 2005., 25 637 -641
AhmedEl-Shenawy, 2014.Predicting the Iron Losses from Steel pipes Due to Erosive Environment Using New Algorithm,WIT Transaction 156 -
Gaungling S.,:, 2005.Recent progress in corrosion and protection of Magnesium alloy,Advanced Engineering Materials 7 10 -
JaeIoong, 2008.Recent Trends and Application of magnesium alloy in the Hyundai and Kia Motors Corporation,Materials Transactions 49 984 -897
Jayabharathy , S.,R.Serarajan,P.Mathiazhagan,Nace International, 2015.Experimental Investigation of Erosion Corrosion Behaviour of Pipe-line Materials with Different Environ-ments, 152 -
LeBozec , N., M.,Johnson and D.,Thierry, 2004.Atmospheric Corrosion of Magnesium alloy: Influence of Temperature, Relative humidity and Chloride deposition,Corro-sion 6 356 -361
LeiWang, 2010.Tadashi Shinohara and Bo-ping Zhang, Corrosion behaviour of Mg, AZ31 and AZ91 in dilute solution,Journal of Solid state Electro. Chem 14 1897 -1907
Makar. G.L.,J.Kruger, 1993.,International material review 38 139 -
Nesic. S.,K.Bremhorst,K.S.Yang, 2000.Testing for Erosion corrosion under distributed flow conditions using Rotating Cylinder with a Stepped Surface,Corrosion 56 -
NicholasLutsey, 2010.Review of Technical litera-ture and trends related to automobile mass reduction technology,UCD-ITS-RR-10-10 -
RajanAmbat,W.Zhou, 2000.Evaluation of microstructural effect on corrosion behaviour of AZ91 magne-sium alloy,Corrosion Science 42 1433 -1455
Rajaram. S.S.,T.J.Harvey,R.J.K.Wood, 2009.Erosion corrosion resistance of engineering materials in Various test condition,Wear 267 244 -254
Sameer K.D. and K.N.S.,Suman, 2014.Selection of Magnesium alloy by MADM methods for automobile,I. J. Engineering and Manufacturing 2 31 -41
Singh. I.B.,M.Singh,S.Das, 2015.A compa-rative corrosion behaviour of Mg, AZ31 and AZ91 alloy in 3.5% NaCl solution,Journal of Magnesium and alloy 3 142 -148
Thirumalaikumarasamy,K. Shanmuga and V.,Balasubramanian, 2014.Influence of Chlor-ide ion concentration on immersion corro-sion behaviour of plasma sprayed alum-ina coating on AZ31 magnesium alloy,Journal of Magnesium alloy 2 325 -334
Thirumalaikumarasamy,K. Shanmuga and V.,Balasubramanian, 2014.Comparison of the corrosion behaviour of AZ31 magnesium alloy under immersion test and potentio-meter polarization test in NaCl,Journal of Magnesium alloy 2 36 -49
0

Citations

0

Downloads

20

Views