Structural analysis using Finite Element Method gives a preliminary assessment of dynamic behavior of mechanical structures in order to establish the guidelines for designing the experiment. The main objective of this study was to develop a methodology of seismic analysis of electronic cabinets using ANSYS. Generally, two approaches i.e. transient analysis and response spectrum analysis are adopted for the seismic analysis in ANSYS. Since, the given loading was in time domain, therefore, transient structural analysis was preferred for the detailed dynamic investigation of electronic cabinet. The cabinet was modeled with Beam188 and its modal analysis was performed rendering the fundamental natural frequency of 8.94Hz, sufficiently close to the experimentally measured frequency of 8.33Hz. Subsequently, Transient analyses were performed for horizontal components of ground motion that resulted in peak displacement of 37mm and 28mm at the top of the cabinet which were in good agreement with experimentally measured maximum displacement of 40mm and 30mm at the same location, respectively. In addition, peak accelerations obtained from transient analyses were 0.6g and 0.82g while the experimentally measured peak accelerations were 0.8g and 0.89g respectively. It can be concluded that transient analyses in ANSYS produced equivalently reliable assessment of dynamic behavior of electronic cabinets.