No Detail Found!

Redundant Capability Analysis of Input-series Output-series Multi-modular DC-DC Converter.

Author(s)
SM JISKANI Department of Electrical Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
AM SOOMRO Department of Electrical Engineering, Mehran University of Engineering, & Technology, Jamshoro, Pakistan
S TALPUR Department of Computer Systems Engineering, Mehran University of Engineering, . & Technology, Jamshoro, Pakistan
SD KALHORO Institute of Business Administration, Community College NosheroFeroze, Pakistan
AR CHACHAR Department of Electrical Engineering, Mehran University of Engineering, & Technology, Jamshoro, Pakistan
Abstract
This paper analyzes input and output voltage behavior for multi-modular DC-DC converter when due to fault conditions, any module is totally bypassed and its output and input voltages are shared by other healthy modules (Redundancy). Modularization is better substitute to eliminate high cost, low voltage capabilities of converter by employing module replicas to build different power converters or even enhance the efficiency of converter due to inherent redundancy and hot-swap characteristics. The model is built through the use of Matlab Simulink tool and the model validates the above statement as the load voltage remain unaltered before and after fault.
Publication Details
Page(s) 537-540
DOI DOI not available
Published Journal: Sindh University Research Journal, Volume: 48, Issue: 3, Year: 2016

Request the full text from PASTIC

References
Konstantinou , G., 2013.Active redundant submodule configuration in modular multilevel converters,Power Delivery 28 2333 -2341
Liu , G.,Z. Xu,, 2015.Optimized control strategy based on dynamic redundancy for the modular multilevel converter,Power Electronics 30 339 -348
Pan , Z.,R. A.Bkayrat, 2010.Modular motor/converter system topology with redundancy for high-speed, highpower motor applications,Power Electronics 25 408 -416
Sha , D., 2012.Duty cycle exchanging control for input-series-output-series connected two PS-FB dc-dc converters,Power Electronics 27 1490 -1501
Sha , D., 2014.A General Control Strategy for InputSeries-Output-Series Modular DC-DC Converters, 29 3766 -3775
Siri , K.,M.Willhoff,K.Conner, 2007.Uniform voltage distribution control for series connected DC-DC converters, 22 1269 -1279
Song , W.,A. Q.Huang, 2010.Fault-tolerant design and control strategy for cascaded H-bridge multilevel converter-based STATCOM, 57 2700 -2708
White , R. V.,F. M.Miles,EleventhAnnual, 1996.Principles of fault tolerance,APEC'96. Conference Proceedings 18 -25
0

Citations

0

Downloads

55

Views