No Detail Found!

Combustion and Emission Based Optimization of Turbocharged Diesel Engine Run on Biodiesel using Grey-taguchi Method.

Author(s)
MI Masood Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
AN Shah Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
A Aslam Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
M Gul Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
A Naveed Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
M Usman Mechanical Engineering Department, University of Engineering & Technology Lahore-54000, Pakistan
Abstract
in this work it is attempted to optimize the combustion parameters such as instantaneous heat release (IH), cylinder Pressure (P) and rate of change of pressure per degree crank angle (dP/do)) and the emissions characteristics such as NOx and Smoke of a turbocharged direct injection (DI) compression ignition (CI) engine alternatively run on pure biodiesel (B100), diesel and biodiesel-diesel blend (B20) applying Grey Taguchi method (GTM). GTM is used to convert multi variables into a single objective function. The process environment comprising three input parameters (speed of the engine, load and type of fuel) were used in this case. The design of experiment (DOE) was selected on an orthogonal array based on L9 (33). The Optimum Parameters were found on the basis of Grey Relational Grade (GRG) and signal to noise (SN) ratio using GTM. The resulted optimum combination of the input parameters was used to get maximum possible values of IH, P and least possible values of NOx, smoke & dP/do. The higher values of IH and P measure the better performance of the engine, while lower values of NOx, smoke and dP/do are the ultimate objectives of the study. According to the results It was revealed that B100 fuel, 1800 rpm speed and 10% load offer the optimum combination for the desired performance of the engine along with reduced pollutants. Analysis of Variance (ANOVA) based on a software Minitab 16 was used to get the most significant input parameter keeping in view responses. Fuel type and engine load were found to be the dominant factors with 48.16% and 43.18% impact on the output parameters, respectively. Finally the results were validated using Artificial Neural Network (ANN) through Mat lab.
Publication Details
Page(s) 80-90
DOI DOI not available
Published Journal: Technical Journal, Volume: 20, Issue: 3, Year: 2015

Request the full text from PASTIC

Keywords
Biodiesel, Turbocharged, Diesel Engine, Grey Taguchi Method, ANN, SN Ratio, GRG
References
B.Gaikwad,,2014,Comparative analysis of performance, emission and combustion parameters of diesel engine fuelled with ethyl ester of fish oil and its diesel blends,Fuel,132,116-124
Baluch,,2009,Effect of biodiesel on the performance and combustion parameters of a turbocharged compression ignition engine,,,-
,,,Pakistan Journal of Scientific and Industrial Research,4,34-42
Zhi-huaa,,,2009,Experimental investigation of VOCs emitted from a DI-CI engine fuelled with biodiesel, diesel and biodiesel-diesel blend,,,-
,,,Pakistan Journal of Scientific and Industrial Research,52,158-166
R. D. Gorle , D.B.,Meshram , P. L.,Naik , V. S. Narnaware,,2013,Optimization of Effective Parmeter of Jatropha Biodiesel Using Taguchi Method and Performance Analysis Using CI Engine,International Journal of Innovative Technology and Exploring Engineering (IJITEE),3,46-52
B.Yang,A. M.Mellor,S.K.Chen,,2002,,,,-
,,Multiple injections with EGR effects on NOx emissions for DI diesel engines analyzed using an engineering model,SAE Technical Paper,01,10-21
S.Saravanan,S. Sampath,,2009,Gas Science and TechnologyRevue d'IFP Energies nouvelles,,67,491-501
[vii] D. T Hountalas , G. C Mavropoulos,T.C Zannis,,2007,Comparative evaluation of EGR, intake water injection and fuel/water emulsion as NOx reduction techniques for heavy duty diesel engines,SAE Technical Paper,01,04-16
S.Islam,A. SAhmed,A.Islam,S. AAziz,L.C Zian,,2014,Study on Emission and Performance of Diesel Engine Using Castor Biodiesel,Journal of Chemistry,,-
S.Oberweis,,2010,Effect of Biodiesel blending on emissions and efficiency in a stationary diesel engine,International Conference On Renewable Energies and Power Quality (ICREPQ'10).,,-
S.Savariraj,T.Ganapathy,C.G. Saravanan,,,2013,Performance, emission and combustion characteristics of fish-oil biodiesel engine,European Journal Of Applied Engineering & Scientific Research,2,26-32
A. R.Shirneshan,M.Almassi,B.Ghobadian,A. M.Borghei,G. H.Najafi,,2012,Effects of Biodiesel and Engine Load on Some Emission Characteristics of a Direct Injection Diesel Engine,,7,207-212
,2010,Effects of biodiesel on a DI diesel engine performance, emission and combustion characteristics,Fuel,89,3099-3105
A.Karnwal,M. M. Hasan , N.,Kumar , A. N.,Siddique and Z. A.,Khan,,2011,Multiresponse optimization of diesel engine performance parameters using thumba biodiesel-diesel blends by applying the taguchi method and grey relational analysis,International journal of automotive technology,12,599-610
[xiv] R . K,Dr. N.Alagumoorthi,V.Ilangovan,,2010,Optimization of engine operating parameters for turpentine mixed diesel fuelled DI diesel engine Using Taguchi Method,International Journal of Engineering Science and Technology,2,5295-5305
N.Balajiganesh,C. M. Reddy,,2011,Optimization of CI engine parameters using artificial neural,International Journal of Mechanical and Industrial Engineering (IJMIE),1,-
[xvi] M. K. D.Kiani , B.,Ghobadian , T.,Tavakoli , A.M.,Nikbakht , and G.Najaf,,,2010,Application of artificial neural networks for the prediction of performance and exhaust emissions in SI engine using ethanol-gasoline blends,Energy,35,65-69
H.Ghorbani,A. M.Nikbakht,M.Tabatabaei,M.Hosseini,,2011,t e c h n o l o g y a n d E n v i r o n m e n t Managment,International Conference o n B i o,18,-
Brzozowska , K.,Brzozowski , and J. Nowakowski,,2005,An application of artificial neural network to diesel engine modelling,IEEE Workshop on Intelligent Data Acquisition and Advanced Computing Systems: Technology andApplications,,142-146
A. M Maulik,,2014,Parametric Optimization Of Single Cylinder Diesel Engine For Palm Seed Oil & Diesel Blend For Brake Thermal Efficiency Using Taguchi Method,IOSR Journal of Engineering,4,49-54
C. S Chang , R-Chieh,Liao , Kun-Li,Wen,WenPai Wang,,2004,A grey-based Taguchi method to optimize design of muzzle flash restraint device,International Journal of Advanced Manufacturing Technology,24,860-864
G. H.Kawade,,2013,A Review on Optimization of CI Engine Performance Parameters for Biodiesel Fuel Using Suitable Software,Journal of Mechanical and Civil Engineering,5,18-23
D.,,2007,“Analysis of energy release and NOx emissions of a CI engine fuelled on d i e s e l a n d D M E ” , A p p l i e d T h e r m a l Engineering,,27,2095-2103
C.R. , and Kirkpatrick,A.T.,,2001,Internal Combustion Engines-Applied Thermo Sciences”, second edition,,,-
[xxiv] H. S Jailani , A.,Rajadurai , B.,Mohan , A. S Kumar,,2009,Multiresponse optimisation of sintering parameters of Al-Si alloy/fly ash composite using Taguchi method and grey relational analysis. The I n t e r n a t i o n a l J o u r n a l o f A d v a n c e d Manufacturing Technology,,45,362-369
,,,2028 at epoch 4,,-
0

Citations

0

Downloads

133

Views