No Detail Found!

Experimental Modal Analysis of Reinforced Concrete Girder using Appropriated Excitation Technique.

Author(s)
MA Azam Civil Engineering Department, UET Taxila, Pakistan
QUZ Khan Civil Engineering Department, UET Taxila, Pakistan
Abstract
Vibration based structural health monitoring of civil infrastructure is becoming very popular due to advancement in instrumentation and development of more robust and powerful system identification techniques. Damage alters the dynamic characteristics of a structure and this relation is used to identify, locate and assess the severity of damage. Despite of advances in vibration based methods very limited success has been reported for reinforced concrete structures particularly in field applications due to complexity of civil engineering structures, limited measurement points, measurement noise and processing errors. The success of vibration based methods relies on the ability to precisely measure the modal properties. Experimental modal analysis is often carried out to observe the modal parameters among which phase separation methods are very common. Phase resonance methods traditionally used in the field of aerospace and mechanical engineering measures the modal parameters physically rather than mathematically. This paper presents the methodology of phase resonance method with application to a typical reinforced concrete bridge girder reduced to one-fourth scale. Piezoelectric accelerometers at 54 measurement points are used to obtain five modal parameters i.e. natural frequency, mode shapes, damping ratio, generalized mass and stiffness. The comparison shows noticeable variation in extracted modal parameters.
Publication Details
Page(s) 25-33
DOI DOI not available
Published Journal: Technical Journal, Volume: 20, Issue: 3, Year: 2015

Request the full text from PASTIC

Keywords
reinforced concrete, Vibration Based Damage Detection, Experimental Modal Analysis, Force Appropriation Method, Modal Parameters
References
[I] B. Moaveni , , X.,He , , J. P.,Conte ,and J. I. Restrepo,Issue5,,2010,Damage identification study of a seven-story full-scale building slice tested on the UCSD-NEES shake table," Structural Safety,32,347-356
A. P.Adewuyi,Z. S.Wu,,2009,Vibration based structural health monitoring technique using statistical features from strain measurements”,No. 3,4,-
Tommy H,,2009,“Review of vibration-based damage detection and condition assessment of bridge structures using structural health monitoring”. In The Second I n f r a s t r u c t u r e T h e m e P o s t g r a d u a t e C o n f e r e n c e : R e t h i n k i n g S u s t a i n a b l e Development: Planning, Engineering,[iii] Wang, Liang and Chan,,-
,2010,[iv] Yujue Wang, “A Non-destructive Damage Detection Method for Reinforced Concrete Structures Based on Modal Strain Energy”,PhD Thesis,,-
S. W.Doebling,C. R.Farrar,M. B. Prime,,1998,A summary review of vibration based damage identification methods,” Shock and Vibration Digest,30,91-105
[vi] J. M. W. Brownjohn,,2007,Structural health monitoring of civil infrastructure” Phil,Trans. R. Soc. A,365,589-622
C. R.Farrar,K.,,2007,Worden “An introduction of structural health monitoring” Phil,Trans. R. Soc. A,365,303-315
M. I. Friswell,,2007,Damage identification using inverse methods”,Philosophical transaction of the royal society A,365,393-410
O. S.Salawu,,1997,Detection of Structural Damage through Changes in Frequency: A Review”,,19,718-723
A. H.Gandomi,M. G.Sahab,A.Rahaei and M. Safari Gorji,,2008,Development in Mode ShapeB a s e d S t r u c t u r a l F a u l t I d e n t i f i c a t i o n Technique”,World Applied Sciences Journal,5,29-38
D.Montalvao,N. M. M.Maia,A. M. R.Ribeiro,,2006,A Review of Vibration-based Structural Health Monitoring with Special Emphasis on Composite Materials”,The Shock and Vibration Digest,38,295-
E.Balmes,C.Chapelier,P.Lubrina,,February 1995,An evaluation of modal testing results based on the force appropriation method”,Proceedings of IMAC,,-
J. R.Wright,J. E.Cooper&M. J. Desforges,,1999,Normal mode force appropriation theory and application”,Mechanical Systems and Signal Processing,13,217-240
D. R.Prasad,D. R.Seshu,,2010,Study on change in modal parameters of RC beams due to fatigue type damage”,Asian Journal of Civil Engineering (Building and Housing),11,-
H. A.Razak,F. C. Choi,,2001,The effect of corrosion on the natural frequency and modal damping of reinforced concrete beams,Engineering Structures,23,1126-33
F.Daneshjoo,A,,2008,Experimental and theoretical dynamic system identification of damaged RC beams”,Electronic Journal of Structural Engineering,8,29-39
0

Citations

0

Downloads

115

Views