No Detail Found!

Modelling and simulation of flow around wind turbine blade by using actuator surface model.

Author(s)
A. A. Memon Department of Energy and Environment, Quaid-e-Awam University of Engineering, Science and Technology, Nawbshah, Pakistan
H. U. Abbasi Department of Energy and Environment, Quaid-e-Awam University of Engineering, Science and Technology, Nawbshah, Pakistan
A. F. Abbasi Department of Mechanical Engineering Mehran University of Engineering and Technology, Jamshoro, Pakistan
M. Asad Center of Excellence in Advanced Studies and Technologies (CESAT), Islamabad, Pakistan
Abstract
This paper presents the simulation of two dimensional flows around a wind turbine blade by using the improved hybrid model. Modeling of a flow field in wind farm requires prohibitive computational cost due to complex geometry of wind turbine blades. The equivalent simplified models replace the real geometry of wind turbine blades in order to represent flow field with significantly reduced computational cost. The modeling method combines blade element approach for forces calculation and Navier- Stokes equations for the flow field simulation. Blades are replaced with surfaces, where pressure discontinuity is applied which represent normal forces, and source terms are applied in the vicinity of surfaces which represent tangential forces. The improved model results of flow field are then compared with existing models.
Publication Details
Page(s) 695-698
DOI DOI not available
Published Journal: Sindh University Research Journal, Volume: 44, Issue: 4, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

54

Views