No Detail Found!

The setup and validation of a numerical model for wall shear in trapezoidal open channels.

Author(s)
K. Ansari Department of Civil Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
N. A. Memon Department of Civil Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
A. A. Memon Department of Civil Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
Abstract
The validation of a numerical model is done using Computational Fluid Dynamics (CFD) commercial software ANSYS CFX. Six trapezoidal channels which were used by Tominaga et al. (1989) in their experimental studies are modelled. Special emphasis is done on the distribution of shear stress and secondary currents. The channels have the sidewall inclinations of 30°, 46° and 58° to the vertical. The bottom width of the trapezoidal channels is kept constant for each slant angle and only the depth is varied to get different aspect ratios. The roughness on the boundaries is also varied. The results are compared with the published results found in the literature. The results are quiet encouraging and the model may therefore be used with confidence for other similar studies.
Publication Details
Page(s) 613-616
DOI DOI not available
Published Journal: Sindh University Research Journal, Volume: 44, Issue: 4, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

24

Views