No Detail Found!

Harmonics mitigation of industrial power system using passive filters.

Author(s)
Zubair Ahmed Memon Department of Electrical Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Mohammad Aslam Uquaili Department of Electrical Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Mukhtiar Ali Unar Department of Computer Systems Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
With the development of modern industrial technology a large number of non-linear loads are used in power system, which causes harmonic distortion in the power system. At the same time the power quality and safe operation becomes inferior. Therefore mitigation of harmonics is very necessary under the situation. This paper presents the design of two passive filters to reduce the current harmonics produced by nonlinear loads in industrial power system. Matlab /simlink software has been used for the simulation purpose. The results have been obtained with and without installation of filters and then it is observed that after installation of filters harmonics of the current are reduced and power factor is improved.
Publication Details
Page(s) 355-360
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 31, Issue: 2, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

86

Views