No Detail Found!

Removal of neutral red dye from water samples using adsorption on Bagasse and Sawdust.

Author(s)
Shahla Elhami Department of Chemistry Science and Research Branch, Islamic Azad University, Khouzestan, Iran
Hosein Faraji Department of Chemistry Science and Research Branch, Islamic Azad University, Khouzestan, Iran
Mehdi Taheri Department of Chemistry Science and Research Branch, Islamic Azad University, Khouzestan, Iran
Abstract
The neutral red dye is used in textile and leather industries and in environmental research. Therefore, the removal of this dye from the factory wastewaters is environmentally significant. In this research, two very inexpensive, abundant and easily available adsorbents, i.e. sugarcane bagasse and sawdust, were employed to remove the neutral red from water. The effects of various conditions such as pH, electrolyte concentration, adsorbent dose, contact time and agitation rate were studied for the removal of the dye in a concentration of 100mg L-1. The obtained conditions were applied for various concentrations of the dye (100 – 400 mg L-1) and in all the cases, an efficiency of more than 96 % was attained. Adsorption isotherms were studied which were well in line with both Langmuir and Freundlich equations. The possibility of employing columns was studied and good results were achieved. The method was applied for the removal of dye from real samples of different waters.
Publication Details
Page(s) 269-272
DOI DOI not available
Published Journal: Journal of Chemical Society of Pakistan, Volume: 34, Issue: 2, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

68

Views