No Detail Found!

The effect of heat treatment on microstructure and mechanical properties of steels.

Author(s)
Saeed Javid Tajik Mechanical Engineering Department, NWFP University of Engineering & Technology, Peshawar, Pakistan
M. Masud Ahmad Mechanical Engineering Department, NWFP University of Engineering & Technology, Peshawar, Pakistan
Iftikhar Ahmad Mechanical Engineering Department, NWFP University of Engineering & Technology, Peshawar, Pakistan
Jehanzeb Khan Mechanical Engineering Department, NWFP University of Engineering & Technology, Peshawar, Pakistan
Abstract
The effect of cooling rates on the mechanical properties of two grades of steel subjected to heating to 940°C and 760°C is discussed. In ferrite/pearlite steels increased rate of cooling raised the ultimate strength of the material. An increase in the ultimate strength from 6.9 KN to 12.42 KN was obtained for 0.21% Carbon steel and 15 to 19.8 KN for 0.28% Carbon steel. A similar trend in ductility has also been observed. An increase in the cooling rate from 25°C/min to 50°C/min resulted in grain size refinement by 1 mm-la for both grades of steel.
Publication Details
Page(s) 113-116
DOI DOI not available
Published Journal: Journal of Engineering and Applied Sciences, Volume: 17, Issue: 2, Year: 1998

Request the full text from PASTIC

0

Citations

0

Downloads

28

Views