No Detail Found!

Structural transitions in cold rolled austenitic stainless steel.

Author(s)
C. A. Majid Nuclear Material Division, Pakistan Institute of Nuclear Science and Technology (PINSTECH), Islamabad, Pakistan
M. A. Hussain Nuclear Material Division, Pakistan Institute of Nuclear Science and Technology (PINSTECH), Islamabad, Pakistan
Abstract
In this paper effect of rolling reduction on the structure and texture of austenitic AISI stainless steel 304L is described. These investigations were made using X-ray diffraction method of direct pole figure measurement, orientation distribution function (ODF) method and inverse pole figure method at different rolling reduction levels of the specimen. Texture coefficient were calculated. These investigations showed that initially present texture components tended to develop into mostly the single [111] texture. The preferred orientation characteristics of the AISI 304L stainless steel were found to be consistent with the preferred orientations observed in low stacking fault energy face centered cubic (fcc) polycrystalline metals and alloys. The lattice constant of this alloy was computed to be 3.5902±0.0003 Ao. With reduction/drawing, lattice constant was found to increase. A maximum change in this parameter was about 0.3% and it occurred at 55% reduction rate. The excessive reduction of the sample resulted in segregation of the ferritic (bcc) and a disordered phases in the sample.
Publication Details
Page(s) 1-7
DOI DOI not available
Published Journal: Nucleus, Volume: 31, Issue: 1--4, Year: 1994

Request the full text from PASTIC

0

Citations

0

Downloads

32

Views