In view of the high cost of precision land levelling at dead level, a number of alternative field slopes were investigated to determine the optimal surface slope that could be adopted for precision land levelling. Field slopes of 0.1, 0.2 and 0.3 percent were tested and compared with 0 percent slope for their effects on crop yield and distribution of irrigation water. A field size of 4.88 meters width and 65 meters length was maintained under each slope treatment. The results indicated that there was non-significant difference in crop yield among various slope treatments at 5 percent level of significance. No appreciable accumulation of water was observed under 0.1 percent and 0.2 percent slopes, particularly on sandy and loam soils. Under 0.3 percent slopes on clayey soils, however, undesirable accumulation of water at the tail section of field was observed that affected the yield adversely. The crop yields, rate of advance and distribution of irrigation water resulting from 0.1 percent slope, were identical to those achieved from 0 percent slope for all types of soils. These investigations lead to the conclusion that the precise levelling of fields at or below 0.1 percent slope not only reduces the cost of levelling appreciably, but also takes same time to irrigate, causes no appreciable reduction in yield due to downstream water accumulation and gives yield comparable to that obtained from 0 percent grade, and therefore, is suggested to be adopted for field applications.