No Detail Found!

Optimum design of high heat flux components of a fusion reactor.

Author(s)
Asad Majid Centre for Nuclear Studies (CNS), PINSTECH, Islamabad, Pakistan
M. A. Abdou University of California, Los Angeles, California, USA
Abstract
Optimum design of high heat flux components of a fusion reactor was achieved through a multi level optimization process. Initially design variables were identified, and their range of variation was determined through design constraints. The objective function was set to be the maximum permissible heat flux which the limiter or diverter can sustain, without failure, for the life of the limiter or diverter. While performing the higher level optimization simple mathematical models were used to obtain the optimum values of the design variables. The intermediate level of optimization was performed by calculating the stresses in the structure using finite element stress analysis code ANSYS. The optimum values were determined by varying one variable and keeping others constant. The optimum value of the variable was the value for which the stresses in the structure became minimum. Lower level optimization was performed to determine the cross section of the cooling channels in the heat fluxed field. Stress analysis were performed using ANSYS code and optimization was performed using optimization code ADS. The maximum permissible heat flux for beryllium coated limiter and diverter at optimum design point was found to be 3.1 MW/m2 for 10 mm beryllium coated limiter and diverter and about 5.8 MW/m2 for 6mm beryllium coated limiter and diverter.
Publication Details
Page(s) 145-151
DOI DOI not available
Published Journal: Nucleus, Volume: 33, Issue: 3, Year: 1996

Request the full text from PASTIC

0

Citations

0

Downloads

64

Views