No Detail Found!

Effect of weave structure on tensile strength and yarn crimp of three-dimensional fibre woven fabric.

Author(s)
Mazhar Hussain Peerzada Department of Textile Engineering, Mehran University of Engineering and Technology, Jamshoro, Sindh, Pakistan; Department of Textiles and Paper, School of Materials, University of Manchester, UK
Sadaf Aftab Abbasi Department of Textile Engineering, Mehran University of Engineering and Technology, Jamshoro, Sindh, Pakistan
Awais Khatri Department of Textile Engineering, Mehran University of Engineering and Technology, Jamshoro, Sindh, Pakistan
Abstract
Three-dimensional (3D) woven fabric as reinforcement is backbone of composites and becoming the material preferred due to cost saving, high production, near-net shaping and superior mechanical properties. It is very important to determine the mechanical properties of a 3D woven fabric before proposing the particular end use. It may be achieved by utilising a complex engineering data to develop models which can predict the failure mechanism. This paper presents the influence of weave structure on tensile strength of 3D carbon Fibre woven fabric. Three different structures layer to layer, orthogonal and angle interlock weaves have been used. Effect of weave has been investigated in both longitudinal (warp) and horizontal (weft) direction. The effect of crimp on failure mechanism was also studied. It is observed that the crimp interchange between the carbon tows and the binder yarn leads to decreasing load over the fibres (warp and weft). As a result, strength and stiffness may be increased. Layer to layer weave structure was found to have higher strength and moduli (in warp) as well as strength as compared to orthogonal and angle interlock weaves.
Publication Details
Page(s) 47-50
DOI DOI not available
Published Journal: Science International, Volume: 24, Issue: 1, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

33

Views