No Detail Found!

Aspects of product quality and process control in plasto hydrodynamic die-less tube sinking.

Author(s)
M. I. Panhwar Mechanical Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
M. L. Dewani Mechanical Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
A. H. Mallah Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
In conventional tube sinking process the reduction in diameter is achieved by pulling the tube through a tapered die. The minimum bore size of such a die is always smaller than the inlet tube diameter. During the sinking process a suitable lubrication is used to reduce the drawing load, die wear and hence improve the machine life and the surface finish of the product. Nevertheless, the problem of die wear due to metal to metal contact is always present. A new technique of tube sinking has been studied in which the tube is pulled through the die-less reduction unit having stepped parallel bores filled with polymer melts. The smallest borer diameter being greater than the initial tube diameter and the smallest bore size of such a device is dimensionally greater than the nominal tube diameter, thus metal to metal contact and wear, would no longer be a problem. Also discuss how the process be controlled in order that a product of specific size could be obtained and also on the aspects of the quality of the drawn tube.
Publication Details
Page(s) 27-32
DOI DOI not available
Published Journal: Journal of Engineering and Applied Sciences, Volume: 7, Issue: 2, Year: 1988

Request the full text from PASTIC

0

Citations

0

Downloads

40

Views