No Detail Found!

Study of adsorption of olefins and oxygen over Sn-Sb oxide catalyst.

Author(s)
H. U. Memon Chemical Fuel Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
M. A. Memon Chemical Fuel Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
R. A. Qazi Chemical Fuel Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
Quantitative adsorption measurements of propene, isobutene and oxygen were obtained individually over pelleted tin-antimony oxide catalyst. The simple gravimetric adsorption method was used, in which the adsorption was measured by the extension of a silica spring over a range of pressures. All the isotherms used were the modification of, the basic langmuir isotherm. An isotherm was derived empirically termed a -FIRST SATURATION ISOTHERM. This allowed 0- 1 at a finite value of pressure unlike the langmuir isotherm wherefi - 1 when the pressure is infinity. The adsorption on Sn-Sb catalyst needed a higher temperature, and saturation pressure. In Sn-Sb catalyst the adsorption rate increased with rise of temperature. Where the adsorption of isobutene on Sn-Sb catalyst was similar to that of propene adsorption except that the former occurred at lower temperature. Similar results,. were obtained for oxygen adsorption over Sn-Sb catalyst but the adsorption was still at lower temperatures than lsobutene. The available surface for adsorption of propene, isobutene and oxygen increased with the increase of temperature to a smaller extent.
Publication Details
Page(s) 83-91
DOI DOI not available
Published Journal: Journal of Engineering and Applied Sciences, Volume: 7, Issue: 1, Year: 1988

Request the full text from PASTIC

0

Citations

0

Downloads

25

Views