Augers of small diameters (19.1 mm) have been evaluated for injecting fertilizer down into the flooded Maahas clay soil. Simulation of the field soil condition was done by a rotating circular bin and by the use of other pertinent equipment to determine the discharge rate performance of spring wire and sheet sprial augers. A consistent (low variance), uniform and high injection discharge rate was the primary criteria used for identifying desirable auger factors for an efficient mechanism for the fertilizer applicator. A sequential completely randomized design of experiment was used. A high average discharge rate of 130 Kg-N/ha was observed with the use of spring wire auger at 1.5 pitch-diameter ratio, 150 rpm rotational auger speed and 60° angle from the horizontal when using a coarse (black grade) prilled urea. The average power effectively utilized by the injection auger was 6.03 watts and with an input power of 819.3 watts for the whole injection set-up. Intensive injection augers analysis revealed that spring wire auger exceeded the discharge rate performance with the above factorial conditions and specifically for coarse prilled urea. The sheet metal spiral auger, however, had uniformly and consistently injected, fine and coarse prilled urea, into flooded soils, but at a relatively low discharge rates.