No Detail Found!

Operational calibration of a sieve mesh.

Author(s)
M. Ayub Khan Yousufzai Applied Physics Department, University of Karachi, Karachi, Pakistan
Abstract
A technique has been developed for calibrating a sieve mesh. This is done by inspecting the sieve mesh through the image shearing microscope in order to find the sieve aperture distribution of the sieve. This distribution is shown to be Gaussion function. Operative size of the aperture was not justified because all the wires of the sieve mesh do not lie in the same plane, hence the maximum size of the fine particles passing the sieve is larger than the aperture size. Leshonski (9] argued that lightly trapped fine particles should be sized to define the operative access diameter of the powder placed on the sieve. The measurements reported in the paper for sieve aperture, glass beads and coal fine particles trapped in the sieve apertures, after specified period of sieving on Ro-Tap sieving machine, are used to calibrate the given sieve mesh. The average width of each powder distribution corresponds to the nominal size of the sieve apertures.
Publication Details
Page(s) 77-89
DOI DOI not available
Published Journal: Gomal University Journal of Research, Volume: 7, Issue: 1--2, Year: 1987

Request the full text from PASTIC

0

Citations

0

Downloads

34

Views