The Manchar Formation, a Neogene mollasse sequence in the Kirthar Range, consists of alternating units of sandstones and shales/siltstones/claystones, with some conglomerates. The "lower Manchar" has abundant sandstone units, the "middle Manchar" has abundant shale units, and the "upper Manchar" has abundant sandstone and conglomerate units. The "lower Manchar" is most fossiliferous, the "middle Muncher" has almost no fossils, and the "upper Manchar" has only a few fossils. Preliminary results of the paleomagnetic studies show that the fine-grained shale/siltstone/claystone units are suitable for magneto-stratigraphic studies. Paleomagnetic studies show that NRM of many of the samples is composite of a secondary component of remnant magnetization, and a stable, hopefully primary, component of remnant magnetization. AF treatment of upto 400 Oe is helpful to remove the secondary component of remnant magnetization but the stable and primary component can't be obtained with certainty by AF treatment of upto 900 Oe. On the other hand PhD enables to remove the secondary magnetization by heating at 200°C, and also successfully isolates the stable, hopefully primary, component of remnant magnetization. Therefore all samples were subjected to a single step thermal demagnetization at 400 oC, and stable components of remnant magnetization were obtained. These stable directions were used to establish a magnetic polarity reversal sequence. Based on the Middle to Late Miocene faunal contents of the Manchar Formation the observed magnetic polarity reversal sequence is correlated with the Magnetic Polarity Time Scale. This correlation suggests that the sampled part of the Manchar Formation ranges from 15.2 Ma to 9-10 Ma.