No Detail Found!

Mathematical model to simulate the generation of thermal stresses and strain.

Author(s)
Faizullah Abbasi Mining Metallurgical Engineering Department, Mehran University Engineering & Technology, Jamshoro, Pakistan
Abu Baker Memon Mechanical Engineering Department, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Ali Bux Soomro Mechanical Engineering Department, Mehran University College of Engineering & Technology, Nawabshah, Pakistan
Abstract
Thermal stresses and strains are generated as a consequence of hardening treatment to steel components. A mathematical model has been developed to simulate the generation of such stresses and strains in low alloy steel plates. The temperature distribution across the thickness of the plate, during quenching, was calculated using unite difference solution to the differential heat conduction equation. Stress calculations were conducted with the use of the relevant physical and mechanical properties of the steel concerned. The experimental residual stress measurement was done by the layer removal method. A physical interpretation of the generation of thermal stresses at the surface and the centre of the plate at various stages during the quench is presented. The predicted residual stress and strain distributions calculated from mathematical model bear a good correlation with those obtained experimentally.
Publication Details
Page(s) 10-16
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 6, Issue: 3, Year: 1987

Request the full text from PASTIC

0

Citations

0

Downloads

41

Views