The reaction proceeds according to the following equation:Ti.3+ + Co3+ Ti4+ + Co2+ Equivalent weights of these substances were calculated on the basis of these electronic changes. The reaction is very fast and one titration is completed within one man. A special assembly was used for observing the interfering effect of atmospheric oxygen upon the oxidation of titanium (III) to titanium (IV) but it was proved that with the above procedure this special assembly was not needed. Hydrochloric acid was also tried in different concentrations as a medium but 10N sulphuric acid proved to yield the best results. According to some of the results re-ported, titanium (III) can be determined within the limits from 0.947 to 14.205 mg with a maximum error of 3.73%. With further increase in the amount of titanium (III) taken, the error increase to the extent to yield results of no analytical importance. Aluminium, magnesium, calcium and copper do not interfere with the determination of titanium up to the levels as reported. These ions also neither affect the rate of reaction between Co3+ and Ti3+, nor the colour of the indicator at the end point. When the amount, of calcium (II), increases to about 15 folds more to that of titanium (III) in the test solution the error of determination increases to + 1.91% and with about i fold excess of copper (II) to titanium (III) amount in solution the error shoots up to +4.03%. an the other hand Fe3+ and Fe both variously interfere with this determination, the reason being that Fe oxidizes Ti3+ and Pe2+ is oxidized by Co3+. On the basis of these findings it is clear that the method reported here for the determination of titanium is quite convenient, simple, precise, sensitive and accurate. It can be used for the determination of titanium in the presence of calcium, magnesium, and copper.