No Detail Found!

Influence of grain refinement on anisotropy in mechanical properties in wrought magnesium alloy AZ80

Author(s)
M SHAHZAD Microstructral Studies Group, Physics Division, Directorate of Science, Pakistan Institute of Nuclear Science and Technology, Islamabad, PAKISTAN
A. H. QURESHI Microstructral Studies Group, Physics Division, Directorate of Science, Pakistan Institute of Nuclear Science and Technology, Islamabad, PAKISTAN
N HUSSAIN Microstructral Studies Group, Physics Division, Directorate of Science, Pakistan Institute of Nuclear Science and Technology, Islamabad, PAKISTAN
L. ALI Department of Metallurgical & Material Engineering, University of Engineering & Technology (UET), Lahore, PAKISTAN
Abstract
A direct-chill (DC) cast alloys AZ80 has been forward – extruded in a single pass with total degree of deformation (φ=2.5) at two temperature 20 0C and 350 0C. The as-extruded round profiles have been analyzed for microstructural changes i.e. degree of  recrystallization and recrystallized grain size, using optical microscopy. The crystallographic texture has been measure from X- ray diffraction using Co Kα radiation. The results show that the extent of grain refinement increases with the lowering extrusion temperature. The crystallographic texture in both conditions consists of a predominant <10i0> component accompanied by a relatively weaker <112­­­0> component in the extrusion direction. Although, the crystallographic structure at both extrusion temperature remains fairly similar, a fine grain size achieved at lower extrusion temperature reduces the degree of anisotropy in yield stress. A fine grain size inhabits the nucleation of tensile twins under compressive loading and gives a higher compressive yield stress thereby lowering the anisotropy in yield stress.
Publication Details
Page(s) 57-60
DOI DOI not available
Published Journal: Nucleus, Volume: 48, Issue: 1, Year: 2011

Request the full text from PASTIC

0

Citations

0

Downloads

85

Views