No Detail Found!

Pin-Hole Leakage in a Thick-Walled Flange

Author(s)
Liaqat Ali Department of Metallurgical and Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
Khalid M Ghauri Department of Metallurgical and Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
Gul Hameed Awan Department of Metallurgical and Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
Abstract
Formation of a ‘pin-hole’ leading to gas leakage, in a thick-walled flange installed on a high-pressure gas line has been investigated to determine the nature and the cause of the leakage. The investigation was carried out by sectioning the flange along suitable planes and tracing the path of leakage with metallographic examination. It was learnt that the 1-inch dia steel flange had been made by forging followed by drilling a hole in the centre by conventional machining. The examination of metallographic sections revealed that during the forging of the component a forging fold had developed which was deep enough to just reach the location of central hole. The leakage through the fold, which took about 6 months to take a start, happened when the oxide entrapped in the fold had been eaten away by the acidic components of the gases.
Publication Details
Page(s) 24-27
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 9, Issue: 0, Year: 2011

Request the full text from PASTIC

0

Citations

0

Downloads

76

Views