No Detail Found!

Flotation–Spectrophotometric Method for Separation and Determination of Trace Amounts of Copper

Author(s)
Nahid Pourreza Department of Chemistry, Faculty of Science, Shahid Chamran University, Ahvaz, Iran
Hooshang Parham Department of Chemistry, Faculty of Science, Shahid Chamran University, Ahvaz, Iran
Parvin Mirzavand Department of Chemistry, Faculty of Science, Shahid Chamran University, Ahvaz, Iran
Abstract
A flotation–spectrophotometric method for the determination of Cu2+ has been developed. The flotation process is based on the formation of a ternary ion-associate between Cu2+ methylthymol blue (MTB) and cetyltrimethylammonium bromide (CTAB) which is floated at the interface of aqueous phase and n–hexane by shaking in a separating funnel. The aqueous solution is discarded and the adsorbed ion associate (Cu2+–MTB–CTA+) on to the wall of a separating funnel is dissolved in a small volume of methanol solvent and its absorbance is measured at 556 nm. The apparent molar absorptivity (e) of the ion associate was determined to be 6.1×104 L mol-1 cm-1. The calibration curve was linear in the concentration range of 10-400 ng mL-1 of Cu2+ with a correlation coefficient of 0.9994. The limit of detection (LOD) was 6.7 ng mL-1. The relative standard deviation (RSD) for 50 and 300 ng mL-1 of Cu2+ was 3.9% and 1.3% (n=7), respectively. The method was successfully applied to the determination of Cu in water samples from water treatment process of Ramin power plant, Iran.
Publication Details
Page(s) 1352-1355
DOI DOI not available
Published Journal: Journal of Chemical Society of Pakistan, Volume: 34, Issue: 6, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

65

Views