No Detail Found!

Hydrogen absorption and desorption performance of Magnesium-Aluminium alloys produced by powder metallurgy.

Author(s)
Muhammet Ali Nalbant Atatürk University, Engineering Faculty Department of Chemical Engineering, Turkey
Özlem Korkut Atatürk University, Engineering Faculty Department of Chemical Engineering, Turkey
Abstract
The main scope of this study is investigating the hydrogen storage and desorption performance of Mg: Al (90:10), Mg17Al12 and Mg2Al3 alloys using a volumetric method. In the experiments, hydrogen pressure introduced into a reference volume was at approximately 20 Bar. Mg-Al alloys were prepared by a powder metallurgy technique. Pressing pressure levels of alloys were altered as 200, 400 and 600 MPa. Upon XRD patterns, after the pressing and sintering, β-Mg2Al3 and Mg:Al(90:10) phases decomposed into γ-Mg17Al12, Mg and Al compositions. γ-Mg17Al12 was the main phase in the hydrogen absorption/desorption process. The highest absorption of hydrogen was observed in the Mg:Al (90:10) alloys. The hydrogen desorption performance of the alloys decreased with the increase of absorption performance. Therefore the lowest desorption was observed in the Mg:Al (90:10) alloys.
Publication Details
Page(s) 439-445
DOI DOI not available
Published Journal: Journal of Chemical Society of Pakistan, Volume: 36, Issue: 3, Year: 2014

Request the full text from PASTIC

0

Citations

0

Downloads

48

Views